If an error occurred or the following message in Chinese (Simplified) language and you cannot find a solution, than check answer in English. Table below helps to know how correctly this phrase sounds in English.
| id |
Chinese (Simplified) |
English |
| 0x40050005 | 某个固件配置信息不完整，所以使用了默认值。 |
Some firmware configuration information was incomplete, so defaults were used. |
| 0x40050006 | 用户配置数据正在覆盖固件配置数据。 |
User configuration data is overriding firmware configuration data. |
| 0x4005000C | 存储输入的键盘数据的信号缓冲区已经溢出(可以通过注册表配置缓冲区大小)。 |
The ring buffer that stores incoming mouse data has overflowed (buffer size is configurable via the registry). |
| 0x4005001B | 在 %1 上无法检测到鼠标的意外删除。 |
Cannot detect surprise removal of the mouse on %1. |
| 0x80050007 | 无法创建 %1 的设备映射项。 |
Unable to create the device map entry for %1. |
| 0x80050008 | 无法删除 %1 的设备映射项。 |
Unable to delete the device map entry for %1. |
| 0x80050012 | 鼠标重置后，设备发出了错误响应。 |
The device sent an incorrect response(s) following a mouse reset. |
| 0x80050019 | 无法创建 %1 的符号链接。 |
Unable to create the symbolic link for %1. |
| 0x8005001A | 串行鼠标不存在或者没有检测到。 |
The serial mouse does not exist or was not detected. |
| 0xC0050001 | 内存不足，无法分配设备 %1 所需的内部存储。 |
Not enough memory was available to allocate internal storage needed for the device %1. |
| 0xC0050002 | 内存不足，无法分配用于保留 %1 的输入数据的信号缓冲区。 |
Not enough memory was available to allocate the ring buffer that holds incoming data for %1. |
| 0xC0050003 | %1 的硬件位置无法转更换为内存管理系统可以识别的数据。 |
The hardware locations for %1 could not be translated to something the memory management system understands. |
| 0xC0050004 | 另一个设备正在使用 %1 的硬件资源。 |
The hardware resources for %1 are already in use by another device. |
| 0xC0050009 | 无法连接 %1 的中断。 |
Could not connect the interrupt for %1. |
| 0xC005000A | ISR 检测到 %1 的驱动程序中有内部状态错误。 |
The ISR has detected an internal state error in the driver for %1. |
| 0xC005000D | Start I/O 过程检测到 %1 的驱动程序中有内部错误。 |
The Start I/O procedure has detected an internal error in the driver for %1. |
| 0xC005000E | Initiate I/O 过程检测到 %1 的驱动程序中有内部状态错误。 |
The Initiate I/O procedure has detected an internal state error in the driver for %1. |
| 0xC0050010 | 鼠标重置失败。 |
The mouse reset failed. |
| 0xC0050016 | 无法设置鼠标采样频率。 |
Could not set the mouse sample rate. |
| 0xC0050017 | 无法设置鼠标分辨率。 |
Could not set the mouse resolution. |
| 0xC0050018 | 无法从鼠标启用传输功能。 |
Could not enable transmissions from the mouse. |
| 0xC005001C | 无法附加到 PnP 设备堆栈。 |
Could not attach to the PnP device stack. |