| 200 | Microsoft 链路层发现协议 |
Microsoft Link-Layer Discovery Protocol |
| 201 | Microsoft 链路层发现协议驱动程序 |
Microsoft Link-Layer Discovery Protocol Driver |
| 210 | IEEE 802.1AB 链路层发现协议(LLDP)。支持 Microsoft 数据中心网络(DCN)。 |
IEEE 802.1AB Link-Layer Discovery Protocol (LLDP). Supports Microsoft Data Center Networking (DCN). |
| 211 | Microsoft LLDP 协议驱动程序 |
Microsoft LLDP Protocol Driver |
| 0x300000B4 | 开始状态 |
Start State |
| 0x300000B5 | 结束状态 |
End State |
| 0x300000B6 | 关闭状态 |
Closed State |
| 0x300000B7 | 打开状态 |
Open State |
| 0x300000B8 | 连接状态 |
Connect State |
| 0x300000B9 | 侦听状态 |
Listen State |
| 0x300000BA | 关联状态 |
Association State |
| 0x300000BB | 身份验证状态 |
Authentication State |
| 0x300000BC | 已建立状态 |
Established State |
| 0x50000002 | 错误 |
Error |
| 0x50000003 | 警告 |
Warning |
| 0x50000004 | 信息 |
Information |
| 0x50000005 | 详细 |
Verbose |
| 0x90000001 | Microsoft-Windows-LinkLayerDiscoveryProtocol |
Microsoft-Windows-LinkLayerDiscoveryProtocol |
| 0x90000002 | Microsoft-Windows-LinkLayerDiscoveryProtocol/Operational |
Microsoft-Windows-LinkLayerDiscoveryProtocol/Operational |
| 0x90000003 | Microsoft-Windows-LinkLayerDiscoveryProtocol/Diagnostic |
Microsoft-Windows-LinkLayerDiscoveryProtocol/Diagnostic |
| 0xB0002710 | 正在启动链路层发现协议驱动程序(LLDP) |
The Link Layer Discovery Protocol driver (LLDP) is starting |
| 0xB0002711 | 正在停止链路层发现协议驱动程序(LLDP) |
The Link Layer Discovery Protocol driver (LLDP) is stopping |
| 0xB000271A | 已启用接口 %1 |
The interface %1 is enabled |
| 0xB000271B | 已禁用接口 %1 |
The interface %1 is disabled |
| 0xB0002724 | 已更新接口 %1 上的本地 MIB |
The local MIB on interface %1 has been updated |
| 0xB0002725 | 已拒绝接口 %1 上的本地 MIB 更新 |
An update to the local MIB on interface %1 was rejected |
| 0xB000272E | 已更改接口 %1 上的参数 %2 |
The parameter %2 on interface %1 has been changed |
| 0xB0002738 | 在接口 %1 上已发送 LLDP 帧 |
An LLDP frame was transmitted on interface %1 |
| 0xB0002739 | 在接口 %1 上已接收 LLDP 帧 |
An LLDP frame was received on interface %1 |
| 0xB000273A | 已拒绝在接口 %1 上接收的 LLDP 帧。%n%2 |
An LLDP frame received on interface %1 was rejected.%n%2 |
| 0xB000273B | 在接口 %1 上已成功验证 LLDP 帧 |
An LLDP frame was successfully validated on interface %1 |
| 0xB0002742 | 在接口 %1 上已发现新邻居%1%n邻居 ID: %3 |
A new neighbor was discovered on interface %1%nNeighbor ID: %3 |
| 0xB0002743 | 接口 %1 上的邻居已更新其 MIB%n邻居 ID: %3 |
The neighbor on interface %1 has updated its MIB%nNeighbor ID: %3 |
| 0xB0002744 | 已删除接口 %1 上的邻居，因为在超时间隔内未收到任何消息%n邻居 ID: %3 |
The neighbor on interface %1 was removed because no message has been received within the timeout interval%nNeighbor ID: %3 |
| 0xB0002745 | 已删除接口 %1 上的邻居，因为收到了关机消息%n邻居 ID: %3 |
The neighbor on interface %1 was removed because a shutdown message was received%nNeighbor ID: %3 |
| 0xB000274C | 系统检测到多个邻居向网络接口 %1 发送 LLDP 数据包。已声明 \"tooManyNeighbors\" 状态。这可能会阻止某些网络操作。 |
The system has detected that there are multiple neighbors sending LLDP packets to the network interface %1. A \"tooManyNeighbors\" state has been declared. This may inhibit some network operations. |
| 0xB000274D | 已清除 \"tooManyNeighbors\" 状态。 |
The \"tooManyNeighbors\" state has been cleared |
| 0xB000274E | 在接口 %1 上从未知邻居接收到消息，而以前检测到的邻居仍处于活动状态。这将延长 \"tooManyNeighbors\" 状态。%n现有的邻居 ID: %3%n接收的邻居 ID: %5 |
A message was received on interface %1 from an unknown neighbor, while the previously-detected neighbor is still active. This will prolong the \"tooManyNeighbors\" state.%nExisting Neighbor ID: %3%nRecived Neighbor ID: %5 |
| 0xB000EA61 | 错误: %1 位置: %2 上下文: %3 |
Error: %1 Location: %2 Context: %3 |
| 0xB000EA62 | 警告: %1 位置: %2 上下文: %3 |
Warning: %1 Location: %2 Context: %3 |
| 0xB000EA63 | 转换为状态: %1 上下文: %2 |
Transitioned to State: %1 Context: %2 |
| 0xB000EA64 | 更新的上下文: %1 更新原因: %2 |
Updated Context: %1 Update Reason: %2 |
| 0xB000EAC5 | SourceAddress: %1 SourcePort: %2 DestinationAddress: %3 DestinationPort: %4 协议: %5 ReferenceContext: %6 |
SourceAddress: %1 SourcePort: %2 DestinationAddress: %3 DestinationPort: %4 Protocol: %5 ReferenceContext: %6 |
| 0xB000EAC7 | 接口 Guid: %1 IfIndex: %2 接口 Luid: %3 ReferenceContext: %4 |
Interface Guid: %1 IfIndex: %2 Interface Luid: %3 ReferenceContext: %4 |
| 0xD0000001 | 系统资源不足 |
Insufficient system resources are available |
| 0xD0000002 | 此帧缺少必需的元素 |
This frame is missing a required element |
| 0xD0000003 | 此帧中的必需元素之一格式错误 |
One of the required elements in this frame is malformed |
| 0xD0000004 | 此帧具有冲突的重复元素 |
This frame has conflicting duplicate elements |
| 0xD0000005 | 此帧具有长度无效的元素 |
This frame has an element with an invalid length |
| 0xD0000006 | 帧结尾标记丢失 |
The End-of-Frame marker is missing |
| 0xD0000007 | 不接受来自多个邻居的帧 |
Frames are not accepted from multiple neighbors |
| 0xD0000008 | 以管理员身份禁用了 LLDP 接收处理 |
LLDP receive processing has been administratively disabled |
| 0xD0000009 | 无法在 MIB 中添加更多信息，因为生成的 LLDP 帧超过链路的最大传输单位(MTU) |
More information cannot be added to the MIB because the resulting LLDP frame would exceed the link's Maximum Transmission Unit (MTU) |
| 0xD000000A | 无法在 MIB 中添加元素，因为它具有无效的长度 |
An element cannot be added to the MIB because it has has invalid length |
| 0xD000000B | 无法在 MIB 中添加元素，因为不允许使用其类型 |
An element cannot be added to the MIB because its type is not allowed |
| 0xD000000C | AdminStatus |
AdminStatus |
| 0xD000000D | MsgTxHold |
MsgTxHold |
| 0xD000000E | MsgTxInterval |
MsgTxInterval |
| 0xD000000F | ReinitDelay |
ReinitDelay |
| 0xD0000010 | TxCreditMax |
TxCreditMax |
| 0xD0000011 | MsgFastTx |
MsgFastTx |
| 0xD0000012 | TxFastInit |
TxFastInit |
| 0xD0000013 | . |
. |